821 HYPEREXTENSION
ROMAN CHAIR
WARNING:
Read and follow all directions
for each step to insure proper
assembly of this product.
USER’S GUIDE
CLASS H
PART # 7349201
REV.A
1
Version: 821108
Revision: 09/24/02
IMPORTANT NOTES
Please note:
* Thank you for purchasing the ParaBody 821 Gym System. Please read these
instructions thoroughly and keep them for future reference. This product must be assembled
on a flat, level surface to assure its proper function.
* This product must be assembled on a flat, level surface to assure its proper function. DO NOT
securely tighten any frame connections until the entire frame has been assembled, unless
otherwise stated.
Tools Required forAssembly
* 3/4” wrench
* 9/16” wrench
* Ratchet with 3/4” and 9/16” sockets
* Adjustable wrench
* Tape measure
Bolt Length Ruler
NOTE: BOLT LENGTH IS MEASURED FROM THE UNDERSIDE OFTHE HEAD OFTHE BOLT.
BOLT LENGTH
BOLT LENGTH RULER:
1/2
1/2
1/2
1/2
1/2
1/2
0
1
2
3
3
4
5
6
1’
2’
3’
4’
5’
1’
2’
3’
4’
5’
1 Square = 1’ X 1’
4
PARTS LIST
KEY
1
QTY
KEY
13
14
15
16
17
18
19
20
21
22
23
QTY
PART #
6588710
6511709
6588309
6588509
6588909
6589109
6589321
6194601
3235205
3235212
3235312
3114702
PART #
3114502
3114403
3114401
3114701
7234801
6692601
3105401
3103102
6590801
6412001
DESCRIPTION
ROLLER PAD SUPPORT
BASE TUBE
DESCRIPTION
3/8” LOCK WASHER
3/8” WASHER
1
2
1
1
1
1
2
2
5
2
8
3
LEA
4
10
8
LEA
LEA
LEA
2
LEA
LEA
LEA
3
HIP PAD SUPPORT
CROSS BRACE
FRONT UPRIGHT
REAR UPRIGHT
PADASSEMBLY
ROLLER PAD
1/2” WASHER
4
8
LEA
LEA
1/2” LOCK NUT
LEA
LEA
LEA
5
4
2” SQ. COVER CAP
3 X 2” END CAP
STARLOCK COLLAR
1 X 8” GRIP
6
1
LEA
LEA
LEA
LEA
LEA
LEA
LEA
7
2
8
2
LEA
LEA
LEA
9
2
3/8 X 1-1/4” BOLT
3/8 X 3” BOLT
3 X 2” INSERT GUIDE
3/8” SPRING PINASSY
2” SQ. END CAP
10
11
12
1
2
LEA 6405201
1/2 X 3” BOLT
3/8” LOCK NUT
6
1/2 X 3”11
15
16
4
5
FIGURE 1
STEP 1:
• SECURELY assemble the CROSS BRACE (4) to the FRONT and REAR UPRIGHTS (5 & 6) using four 1/2 X
3” BOLTS (11), four 1/2” WASHERS (15) and four 1/2” LOCK NUTS (16) as shown in FIGURE 1.
5
6
2
1/2 X 3”
2
15
5
16
17
2
FIGURE 2
STEP 2:
• Insert four 2” SQ. COVER CAPS (17) into the ends of the BASE TUBES (2) as shown in FIGURE 2.
• SECURELY assemble the BASE TUBES (2) to the FRONT and REAR UPRIGHTS (5 & 6) using four 1/2 X 3”
BOLTS (11), four 1/2” WASHERS (15) and four 1/2” LOCK NUTS (16) as shown in FIGURE 2.
1/2
1/2
1/2
1/2
1/2
1/2
0
1
2
3
6
4
5
6
21
22
1
8
19
6
FIGURE 3
STEP 3:
• Insert two 3 X 2” INSERT GUIDES (21) into the end of each of the ROLLER PAD SUPPORT (1) as shown in
FIGURE 3.
• SECURELYassemble the SPRING PINASSEMBLY(22) to the ROLLER PAD SUPPORT (1). See FIGURE 3.
• Slide the two ROLLER PADS (8) onto the ROLLER PAD SUPPORT (1) using two STARLOCK COLLARS (19)
as shown in FIGURE 3.
• Pull back the SPRING PIN and CAREFULLYslide the ROLLER PAD SUPPORT (1) over the REAR UPRIGHT
(6). as shown in FIGURE 3.
18
3/8 X 1-1/4”
9
14
12
6
FIGURE 4
STEP 4:
• SECURELYassemble on 3/8 X 1-1/4” BOLT (9), two 3/8” WASHERS (14), and one 3/8” LOCK NUT (12) into
the top hole on the REAR UPRIGHT (6). See FIGURE 4.
• Insert one 3 X 2” END CAP (18) into the top of the REAR UPRIGHT (6) as shown in FIGURE 4.
7
3/8 X 3” 10
14
23
20
3
14
12
5
FIGURE 5
STEP 5:
• Insert two 2” SQ. END CAPS (23) into the ends of the HIP PAD SUPPORT (3) as shown in FIGURE 5.
• SECURELY assemble the HIP PAD SUPPORT (3) to the FRONT UPRIGHT (5) using two 3/8” X 3” BOLTS
(10), four 3/8” WASHERS (14), and two 3/8” LOCK NUTS (12). See FIGURE 5.
• Slide two 1 X 8” GRIPS (20) onto the HIP PAD SUPPORT (3). (Using water will help slide them on.)
7
3
14
13
9 3/8 X 1-1/4”
FIGURE 6
STEP 6:
• SECURELY assemble the PADS (7) to the HIP PAD SUPPORT (3) using two 3/8” X 1-1/4” BOLTS (9), four 3/
8” WASHERS (14), four 3/8” LOCK WASHERS (13). See FIGURE 6.
THIS CONCLUDES THE ASSEMBLY OF THE 821 HYPEREXTENSION ROMAN CHAIR
1/2
1/2
1/2
1/2
1/2
1/2
0
1
2
3
8
4
5
6
MAINTENANCE
Please note:
* We recommend cleaning your product (pads and frame) on a regular basis, using warm soapy
water. Touch-up paint can be purchased from your ParaBody customer service representative
at (800) 328-9714.
* Inspect equipment daily. Tighten all loose connections are replace worn parts immediately.
Failure to do so may result in serious injury
* PLEASE RECORD THE INFORMATION REQUESTED BELOW. IN THE EVENT
YOU MAY NEED SERVICE YOU WILL BE ASKED FOR THIS INFORMATION.
REMEMBER TO FILL OUT YOUR WARRANTY REGISTRATION CARD AND
MAIL BACK.
MODEL #________________________
SERIAL #_________________________
DATE OF PURCHASE: _____________
DEALERS NAME: _________________
DEALERS PHONE #_______________
SERIAL NUMBER
Thank you for purchasing the ParaBody 821 Gym System.
9
LIMITED WARRANTY
ParaBody extends the following LIMITED WARRANTY to the original owner of the ParaBody products. The Warranty terms apply to IN HOME USE ONLY.
1. LIMITED WARRANTY ON FRAMEAND WELDS. If the frame of the ParaBody product or a weld should crack or break, it will be repaired
or replaced by ParaBody. Terms: Lifetime – for so long as the Customer owns the ParaBody product.
2. LIMITED WARRANTY ON PARTS. If the following parts are defective in material or workmanship, ParaBody will supply replacement parts:
all bolts, nuts, washers, bearings, bushings, pulleys, thumbscrews, collars, cable retaining clips, adjustable pre-stretch slides, roller pad
shafts, allen head bolts, weight selector pin, weight stack shaft, set screws, protector caps, adjustment chain, cotter pin, plunger, spring
and knob. Terms: Lifetime – for so long as the Customer owns the ParaBody product.
3. LIMITED WARRANTY ON CABLES AND UPHOLSTERY. If the coated cables or upholstery are defective in material or workmanship,
ParaBody will repair or replace them, at its option. Terms: Three (3) years.
4. CONDITIONS AND EXCEPTIONS. Any product misuse, abuse or alteration, any attempt to repair by a person other than an authorized
ParaBody Service Center, any improper assembly, accident, or any other condition resulting from occurrences beyond the control of
ParaBody will void this Limited Warranty.
5. REPLACEMENT AND REPAIR EXPENSES. ParaBody will provide only replacement parts or repair under this warranty. The Owner is
responsible for all other costs. Such costs may include, but are not limited to: a. labor charges for service, removal, repair or reinstallation
of the ParaBody product or any component part; b. shipping, delivery, handling and administrative charges for returning parts to ParaBody;
and c. all necessary or incidental costs related to installation of the replacement parts.
6. SHIPPING. If shipping by the Owners is deemed necessary (in sole discretion of ParaBody), parts should be shipped in their original carton
or equivalent packaging, fully insured with shipping charges prepaid. ParaBody will not assume any responsibility for any loss or damage
incurred in shipping.
7. CLAIM PROCEDURES. If service on your ParaBody product is required during the warranty period, please contact our Customer Service
Department at 1-800-328-9714 for instructions regarding returning or replacing parts. Please have available the following information: (i) the
dealer’s name; (ii) the date of purchase; (iii) the serial # (s) of your product (the serial number location is called out on the final assembly
drawing included with your assembly instruction); (iv) a description of the nature of the problem.
8. OWNER’S RIGHT. This Limited Warranty gives you specific legal rights. You may also have other rights, which vary depending on local law.
9. LIMITATION OF IMPLIED WARRANTIES. All implied warranties, except to the extent prohibited by applicable law, shall have no greater
duration than the warranty period set forth above. There are no warranties which extend beyond the description in this Limited Warranty.
Because local laws do not allow limitations on how long an implied warranty lasts, the above limitations may not apply to you.
10. DISCLAIMER. No other express warranty has been made or will be made on behalf of ParaBody with respect to any ParaBody product or
the operation, repair or replacement of any ParaBody product. ParaBody shall not be responsible for injury, loss of use of the ParaBody
product, inconvenience, loss or damage to personal property, whether direct or indirect, and incidental or consequential damages, so the
above limitation or exclusion may not apply to you.
NOTES:
10
LIFE FITNESS CONSUMER DIVISION
14150 Sunfish Lake Blvd. Ramsey Minnesota, 55303 U.S.A.
Tel: 763.323.4500 Fax: 763.323.4797
800.328.9714 (Toll-free within the U.S. and Canada)
INTERNATIONALOFFICES
Life FitnessAtlantic BV
Life Fitness (UK) Ltd.
QueenAdelaide
Ely, Cambs CB7 4UB
United Kingdom
Phone CSS: (01353) 665507
Fax CSS: (01353) 666719
Atlantic Headquarters
Bijdorpplein 25-31
2992 LB Barendrecht
The Netherlands
Phone: (180) 646 666
Fax: (180) 646 703
Life Fitness EUROPE GmbH
Siemensstrasse 3
Life Fitness Benelux N.V.
Bijdorpplein 25-31
85716 Unterschleissheim
Germany
2992 LB Barendrecht
The Netherlands
Phone: (089) 31 77 51-0
Fax: (089) 31 77 51 99
Phone: 31 (180) 64 66 69
Fax: 31 (180) 64 66 99
Life Fitness Japan
8/F, Nippon Brunswick Building
5-27-7 Sendagaya
Shibuya-Ku, Tokyo 151-0051
Japan
Phone: 81 (3) 3359-4309
Fax: 81 (3) 3359-4307
Life Fitness Italia S.R.L.
Via Elvas 92
39042 Bressanone
Italy
Phone: 39 (472) 835-470
Fax: 39 (472) 833-150
Life Fitness Do Brazil
Al. Rio Negro, 433-Predio 2-Sala 2
3º andar (Confab)
Aplhaville-Barueri-Sao Paulo
CEP: 06454-904
Life FitnessAsia Pacific Limited
Room 2610, Miramar Tower
132 Nathan Road, Tsimshatsui
Kowloon, Hong Kong
Phone: (852) 2891-6677
Fax: (852) 2575-6001
Brazil
Phone: 55 (11)7295-2217
Fax: 55 (11) 7295-2218
11
|