Location of Features
Front and Back View
R
MD
For Customer
Assistance Call:
1
2
3
4
1-800-663-5954
iP642M
AM/FM Digital Radio Boombox
Designed for iPod shuffle Playback
Instruction Manual
10
11
9
8
7
6
5
12 13
14
Thank you for your purchase of this Magnasonic product.
Please read this Instruction Manual carefully before using
product to ensure proper use. Keep this manual in a safe
place for future reference.
1. VOLUME 6 Button
2. Handle
8. FUNCTION Button
9. Tuning
Button
3. Plug Dock for use with iPod
4. VOLUME 5 Button
5. Display
10. MEMORY UP Button
11. AUX IN
12. Battery Compartment
13. POWER ON/OFF
14. DC Input Jack
6. Tuning
Button
7. MEMORY DOWN Button
IMPORTANT
Since CD circuitry may cause interference to other radio or television tuners nearby,
switch this unit off when not in use or move it away from the affected radio tuner.
Battery Power Source
NOTE:
1. Open the battery compartment at the bottom of the unit and insert 4 x “C” size batteries
(not supply) following the polarity diagram shown inside the battery compartment.
This digital apparatus does not exceed the Class B limits for radio noise emissions
from digital apparatus as set out in the Radio Interference Regulations of Industry
Canada. These limits are designed to provide reasonable protection against harmful
interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However,
there is no guarantee that interference will not occur in a particular installation. If this
equipment does cause harmful interference to radio or television operation (which can
be determined by turning the equipment off), the user is encouraged to try to correct
the interference by one or more of the following measures:
2. Do not mix new batteries with the old ones when using the unit.
3. Batteries should be removed from the compartment if the unit is not to be used for long
time.
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the
receiver is connected.
• Consult the dealer or an experienced radio / TV technician for help.
This Class B digital apparatus complies with Canadian ICES-003.
Using The AC Adaptor
1. Insert the DC adaptor at the end of the adaptor cord into the DC IN Jack at the rear
side of the unit.
2. Plug the other end into an AC Outlet.
AC Outlet
AC Plug
DC Plug
Note: Only use with the supplied AC Adapter. Using with another AC adaptor could
cause damage. Remove both the DC Plug and AC plug to disconnect the AC
adaptor when not necessary.
|