H A I R S T R A I G H T E N E R
M o d e l :
WB20310
3
0
W
PLEASE READ ALL INSTRUCTIONS BEFORE USE
2 y e a r g u a r a n t e e
WB20310_HAIRSTRAIGHTENER_IM.indd 1
6/3/2010 11:51:22 AM
The hair straightener has a built-in ceramic PTC
system to keep the temperature of the ceramic
plates constant.
-In order to straighten the hair perfectly, take a
strand which is not too thick.
-Starting at the root, place it between the plates in a
perpendicular position and gently pull downwards
until reaching the ends of the strand. If necessary
repeat this action various times.
-Apply the same technique to the rest of the hair.
-When finished, disconnect the appliance by put-
ting the switch in the stop position and unplug it
from the socket.
Safety advice and cautions
-Read these instructions carefully before switching
on the appliance and keep them for future consul-
tation.
-This appliance is only for domestic use, not
industrial use.
-Do not leave the appliace connected and
unattended when not in use.
Moreover, this will allow saving energy and
extending the life of the appliance.
-Do not leave the appliance within the reach of
children or disabled individuals.
-Before connecting the appliance to the mains,
check that the voltage indicated on the nameplate
coincides with the mains voltage.
-Do not use the appliance near the shower, bath or
other containers holding water.
Cleaning
-Disconnect the aplliance from the mains and leave
to cool before proceeding to clean.
-Clean the appliance with a damp cloth and dry af-
terwards.
-Before picking up the appliance after falling into
water disconnect it immediately.
-Never submerge the appliance in water or any
other liquid or put it under running water.
-Do not use solvents or abrasive products for
cleaning.
-Do not use the appliance on wet hair,
-Do not use the appliance if the cable or plug are
damaged, or if not functioning correctly.
-Keep the cable away from hot surfaces.
-Do not strecth, bend or warp the cable round the
appliance.
Problems and Solutions
Should the mains connection fail, do not try to re-
place it since this is potentially dangerous. Take
the appliance to an authorised Technical Support
Service. The same applies to any other type of
problem.
-Do not throw or insert anything into any of the
appliance's cavaties.
-Do not leave the appliance switched on top of any
surface.
-Do not use the appliance where aerosols are in
use.
This appliance complies with the Low Voltage Di-
rective 73/23/EEC and with Electromagnetic Com-
patibility Directive 89/336 EEC.
-Do not position the hot parts of the appliance on
heat-sensitive surfaces.
-The applaince heats when in operation. Do not
bring the hot parts into contact with the skin to
avoid burns.
-Never leave the appliance connected to the
socket.
-Never put the appliance away when it is still hot or
connected.
-No liablility is accepted for damage caused
through inappropriate handling or use other than
that stipulated in this manual.
-Never wrap the cable around the appliance when
it is still hot.
Instructions for use
-Connect the appliance to a socket. This is a mul-
tivoltage appliance, it can therefore be used in any
part of the world (from 110V to 230V).
-Operate the start/stop switch.
-Select the desired temperature using the tempera-
ture control (110°C min - 200°C max).
-The pilot light will come on indicating that the ap-
pliance is heating up.
WB20310_HAIRSTRAIGHTENER_IM.indd 3
6/3/2010 11:51:26 AM
27 Nourse
Avenue Epping
2
Cape Town
P.O. Box 975 Eppindust 7475 South Africa
Tel: +27 21 534 8114 Fax: +27 21 534 8086
Service Centre Share Call: 086 111 5006
w e b : w w w. c r e a t i v e h o u s e w a r e s . c o . z a
WB20310_HAIRSTRAIGHTENER_IM.indd 4
6/3/2010 11:51:26 AM
|